วงจรปรับความสว่างหลอดสโตปไลท์



R1 250 Ohm 10 Watt Resistor
R2 500K Pot
R3 680K 1/4 Watt Resistor
D1,D2 1N4004 Silicon Diode
C1, C2 22 uF 350V Capacitor
C3 0.47uF 400 Volt Mylar Capacitor T1 4KV Trigger Transformer (see "Notes")
L1 Flash Tube (see "Notes")
L2 Neon Bulb
Q1 106 SCR
F1 115V 1A Fuse
Misc Case, Wire, Line Cord, Knob For R2
Notes
1. T1 and L1 are available from The Electronics Goldmine
2. This ciruits is NOT isolated from ground. Use caution when operating without a case. A case is required for normal operation. Do not touch any part of the circuit with the case open or not installed.
3. Most any diodes rated at greater then 250 volts at 1 amp can be used instead of the 1N4004's.
4. Do not operate this circuit at high flash rates for more than about 30 seconds or else C1 and C2 will overheat and explode.
5. There is no on/off switch in the schematic, but you can of course add one.

 
 

วงจรไฟฟ้า หมายถึง ทางเดินของกระแสไฟฟ้าซึ่งไหลมาจากแหล่งกำเนิดผ่านตัวนำ และเครื่องใช้ไฟฟ้าหรือโหลด แล้วไหลกลับไปยัง แหล่งกำเนิดเดิม

วงจรไฟฟ้าประกอบด้วยส่วนที่สำคัญ 3 ส่วน คือ
   1. แหล่งกำเนิดไฟฟ้า หมายถึง แหล่งจ่ายแรงดันไฟฟ้าไปยังวงจรไฟฟ้า เช่นแบตเตอรี่
   2. ตัวนำไฟฟ้า หมายถึง สายไฟฟ้าหรือสื่อที่จะเป็นตัวนำให้กระแสไฟฟ้าไหลผ่านไปยังเครื่องใช้ไฟฟ้า ซึ่งต่อระหว่างแหล่งกำเนิดกับเครื่องใช้ไฟฟ้า
   3. เครื่องใช้ไฟฟ้า หมายถึง เครื่องใช้ที่สามารถเปลี่ยนพลังงานไฟฟ้าให้เป็นพลังงานรูปอื่น ซึ่งจะเรียกอีกอย่างหนึ่งว่า โหลด สวิตซ์ไฟฟ้านั้นเป็นส่วนหนึ่งของวงจรไฟฟ้า มีหน้าที่ในการควบคุมการทำงานให้มีความสะดวกและปลอดภัยมากยิ่งขึ้น ถ้าไม่มีสวิตซ์ไฟฟ้าก็จะไม่มีผลต่อการทำงานวงจรไฟฟ้าใดๆ เลย